This controller can convert 5V 3-pin ARGB product to SATA power supply controller. It does not need the support of the motherboard, and can be directly plugged into the power supply SATA interface for power supply.

Portable size: cable length: 3PIN: 160 (+/-10) mm. SATA: 500 (+/-10) mm. ARGBmini controller: length is 50mm/1.97inch, width is 22mm/0.87inch, height is 8.5mm/0.34inch.the 3-pin interface adopts the extension cable design, it solves the problem of insufficient wire length.

Through the built-in lighting mode of the controller, the lighting control of 5V3-pin ARGB products can be realized. The controller has dozens of built-in lighting modes, such as monochrome, trotting light, rainbow and other modes , so that hosts that do not support 5V ARGB light synchronization can also create cool light.Note: This controller does not support connecting motherboard software to control light synchronization.

M key: Click to switch to the next lighting mode, and you can cycle to switch the controller's own lighting mode. S key: Single click to switch the light conversion speed, there are 8 gears can be switched cyclically, long press the S key for 4 seconds to turn off the light, and then long press for 4 seconds to turn on the light.

C key: Click to switch to other light colors in the same mode or make the light cycle in reverse, long press the C key for 5 seconds to switch the light brightness, a total of 6 levels of brightness can be cycled.The 3-pin interface has a protective cover to protect the needle from bending and deformation.